My Autopano Pro forum

tived · 2008-08-10 04:53:10

Hi everyone,

I have been shooting some pano's which were not meant to be 360 degrees per say. but I have I have shot with all the way around, to make sure I could crop where I wanted. but almost every time, Autopano and PTGui have made the center of the pano where the two ends meet up?

I am still driving these two programs with my "L-plate" learners permit :-) <this may just be an Australian Joke!>

How can I tell either programs that I want the other two ends to join and be the center?

Sorry if I haven't explained myself well enough, any help is greatly appreciated

thanks

Henrik

digipano · 2008-08-10 07:22:01

Both in APP & PTgui you can do that by changing the Yaw parameters by +90° or -90°

For some reason the image is not showing up so read this page
http://www.autopano.net/wiki/action/vie … ry_Editing

Last edited by digipano (2008-08-10 07:26:15)

Warren Sarle · 2008-08-10 12:55:29

And both APP and PTGui have a tool that you click on the point where you want the center of the pano to be.

tived · 2008-08-11 04:40:36

thanks, i will have a go at this tonight. problem is that i probably completely understand the science behind this
but i am still loving it

Henrik

Last edited by tived (2008-08-11 04:41:15)

My Autopano Pro forum

Announcement

#1 2008-08-10 04:53:10

Having problem relocating the center of the pano, 360degree but join..

#2 2008-08-10 07:22:01

Re: Having problem relocating the center of the pano, 360degree but join..

#3 2008-08-10 12:55:29

Re: Having problem relocating the center of the pano, 360degree but join..

#4 2008-08-11 04:40:36

Re: Having problem relocating the center of the pano, 360degree but join..

Board footer